HOW IT WORKS

w'air uses cold tap water and a little detergent to spot clean, deep clean or simply refresh...

w'air CEO, Jonathan Hewlett, explains how this unique fabric care device is both easy to use but also incredibly versatile around the home - from clothing and carpets to sneakers and sofas.

and always remember the w’air three golden rules

  • 1

    1

    The sooner you treat items with your w'air, the better the results will be

  • 2

    2

    Always use the correct w’air products – using the wrong products will damage your w’air and you may invalidate your warranty

  • 3

    3

    If in doubt about how to use your w'air, download the app (via iOS or Android), use the QR code above or visit frequently asked questions

1 of 3

how to use your device, step by step

  • Getting started

  • Remove stains

  • Deep clean delicates

  • Refresh clothes and fabrics

1. Remove your w'air from the packaging and connect the power cord

2. Fill the water reservoir with cold tap water to the fill line and add about 4 squirts of w'air detergent

3. Turn on your w'air (via the ON/OFF switch next to the power cord socket) and take the wand from its cradle

4. Press the blue button and you’re ready to go!

Buy now

1. Carefully remove / wipe away any excess spillage then place your item on the backing mat on a hard, flat surface

2. Make sure the w'air backing mat is directly under the stain (towel-side up)

3. Check User Guide or w’air app to see if pre-treatment is required. If so, test on a small, discrete area first then apply liberally making sure you moisten the entire area of the stain

4. Wait for the pre-treatment to completely dry before continuing (usually 10-15 minutes)

5. Place the wand directly on top of the stain, press and hold the button and rub the area well

6. Air dry in minutes and you’re ready to goIf the stain doesn’t go, repeat from step 3 onwards

7. Clean the wand thoroughly with warm water after use

1. Lay your item onto a hard, flat surface

2. Hold the wand as close as possible (without touching it) then press and hold the blue button on the wand

3. Pass over the fabric paying particular attention to areas such as cuffs, collars and armpits on shirts and tops

4. Rinse clean by dipping gently in cold waterHang out to dry naturally

5. Clean the wand thoroughly with warm water after use

1. Lay your item onto a hard, flat surface

2. Hold the wand as close as possible (without touching it) then press and 
hold the blue button on the wan

3. Pass over the fabric making sure all areas are refreshed

4. Air dry in minutes and you’re ready to goClean the wand thoroughly with warm water after use